What is the last step in ISO 9001 registration?
Which amount does include in "wages" amount as per payment wages Act?
What is the file for lock repair and filing hard notches in keys?
The expansion of QMS is..........
What is the formula for perimeter of a sector?
What is the area of the lamina?
Under Factories Act, the workers weekly hours should not exceed more than......
Which factor is NOT concerned with occupational health and safety?
What is the area of conical object?
What is the minimum percentage of employee's contribution from the basic salary, as per EPF Act, 1962?
What is the process to refine the structure of steel component?
What is the length of arc of a sector whose radius is 3.6 cm and angle is 36°?
Where is circular taper key used?
What is the area of the sector, whose diameter is 40 mm and angle is 120°?
As per factories act 1948 canteen should be provide in the factory if workers are more than
What is the name used for word “waste"?
Which key is useful for fitting on tapered shafts?
Fishbone chart is also called a......
What is the area of the irregular surfaces?
Which method of surface hardening, the surface remains free from scales?
Which scheme of Act provides health insurance requirements for workers?
How the plain bearings are kept in a position without allowing them to rotate along with the shaft?
Which key has rectangular cross section is fit into keyway cut on both shaft and hub?
What is the process if the steel is heated above critical temperature and soaking it for sufficient time and cooling it very slowly within furnace?
What is the area of the irregular surfaces?
In PDCA cycle, 'P' stands for....
What is the length of arc of a sector, whose radius is 15 cm and angle is 40°?
Which one of the following is an air pollutant?
What is the advantage of lock washer?
Which formula is correct to quantify the quality
Under factories act the restriction on working time of women
What is the name of screw?
What is the name of operation?
What type of abrasives are used in honing cast iron and non-ferrous materials?
What is the radius of the circle if the angle of sector is 90° and the area of the circle is 196 cm2?
Which method of surface hardening is done in a heated salt bath?
What is the area of the surface?
What is the expansion of ILO?
