the diameter of the screw at the crests is callled _____________diameter , while that at the roots is called ________________diameter .
What is the accuracy of Vernier bevel protractor?
What is known for the temperature at which any solid melts into liquid?
in a small size hole the thread is cut by a tool called
What is a shortcut key for “select all” command?
What is the name of chisel?
What is the boiling point of aluminium?
What is the reading of an outside micrometer (British)?
Low level language is also called
The expansion of RAM is _______
Which one is an exclamatory sentence
Which one has the highest thermal conductivity?
What is the name of the part marked as X ?
What is the name of hammer?
What is the name of operation?
What is the property of metal that permits no permanent distortion before breaking?
The word that expresses a sudden and strong feeling is called______
What is the reason for scratches produced on filed surface?
In MS Excel, collection of work sheet is known as ____
Why slight convexity is given on the face of hammer?
What is the S.I unit of heaT?
Which one is in active voice?
Which marking media is applied to rough forgings and castings?
Why the hand taps are chamfered at the lead?
A screw thread is formed by cutting a __________groove on a cylindrical surface
Fill in the blank with proper pronoun “I made this cake _______
A software application used to enable computer users to locate and access web page is called _______
Why surface plates are made of stress relieved good quality cast iron? |
Which metal cutting saw is used for cutting different profiles?
___________ thread is used in the lead screw of the lathe .
What is the pitch of hacksaw blade used to cut conduit and other thin tubes?
knukcle thread is a modified form of ____________ thread.
Curriculum Vitae (CV) is also known as..
Which is the unit of current?
What is the name of angle between the axis of chisel and job surface while chipping?
Gesture “biting nails” shows ___
the thread cut on the surface of the rod is called________thread, while that cut on the surface of a hole is called ___________ thread
Name the part marked as x in depth micrometre.
when the drawing is drawn of the same size as that of the object, the scale used is __________
large size threads are cut on a machine called _________
What is the use of bevel protractor?
What is the name of drilling machine?
Which vice is used for holding hollow cylindrical jobs?
What is the SI unit of pressure?
: Which machine converts mechanical energy into electrical energy?
Which is used to finish the resharpened divider point? |
What is the flow of electrons in any conductor? |
when measurements are required in three units ________scale is used
