Which chisel used for squaring materials at the corners, joints?
measurements from the scale to the drawing are transferred with the aid of a
Name the part of file marked as x .
Add description here!
Name the part marked as x.
Surface area of cube of edge ‘a’ is:
write the shortcut key for 'cut' command
Commas, full stops, question marks – are examples of ------------.
If 295 ÷ 14.5 = 20.34 , then 29.5 ÷ 1.45 = ?
Which marking media is poisonous?
What is the name of the vice?
Add description here!
The singular form of lenses is_____
The reciprocal of a proper fraction is
The shape of an ice-cream cone is a combination of:
Which caliper is used to mark the centre of round bar?
What is the name of hammer?
Which marking media provide clear lines on machine finished surfaces?
What are the three factors causes fire?
________are used to drawing curve which cannot be drawn by a compass
uses of the set square ,t-square , scale and protractor are combined in the ___________
for drawing of small instruments , watches etc __________-scale is always is always used
Radius of a cylinder is 7cm. Height is 10 cm find the total area ?
Name the part of a hammer marked as x.
to draw or measure angles __________is used
Name the part marked as x of the file.
Which file is used to make the job close to the finishing size?
What is the use of a try square?
The silent letter in the word 'answer'
What is the name of chisel?
Which fire extinguisher is used for flammable and running liquid fire?
What does the symbol denotes?
What is the colour code for plastic waste bin?
Change the verb "took" in the passive voice…
Workplace etiquette means to……
Candela is the unit of which of the following?
Always -------------- your mobile phone --------------- silent mode.
In a right angle triangle Hypotenuse is 5 cm, Height is 3cm find base ?
to remove unnecessay lines __________is used
the size of the letter is described by the
What is the material to manufacture bench vice?
LCM of two number is 24, HCF of two number is 4. If one number is 8 find another?
The edge of the drawing board on which t-square is made to slide is called is
What is the name of sign?
the two parts of the t-square are _____and __________
How much less is 10.78 than 30.64 ?
Which one is an input device ?
