the taper on a shaft is indicated along the
Which standard pipe fitting is used to close a pipe line having internal thread?
What is the name of bearing?
What is the name of part marked as ‘x’ in the pipe joint?
Applications and services offered over the internet are called ------------
the thread cut on a surface of a rod is called ______________thread
Participants in live seminars and discussions can ------------- ------- when it is enabled.
What is the term, if an article is purchased?
The work undertaken by a person for a period of time is called______
What is the name of pipe line symbol?
What is the position of eccentric reducer are used in pipe lines?
What is the name of the pipe fitting?
___________--thread is used in the lead screw of the lathe
a sketch is considered to be good when its feathers are shown in correct _________
Giving information in a manner that does not attack a person, but brings possible changes to the behaviour is called ------------------
When we work with others, it is called__________
Which one is the ratio of stress?
The process of learning a completely new set of skills to perform a different type of a job is_________
What is the value of x if 13+x =20?
What is the value of x if x-y=6 and x+y=8
What is the name of bearing?
Taking decisions on your own, after carefully thinking about them is the quality of_______
Which type of wrench is used for more than 50 mm diameter pipe to tight with heavy gripping?
Which type of bearing used for very heavy radial load?
What is the angle of deviations provided on elbows and bends in pipe works?
Excel is used to ----------------------.
What is the name of the pipe fitting?
What is the disadvantage of thrust ball bearing?
What is the ratio of change in length to original length?
What is the name of part marked ‘X’?
The unit of resistance is
What is the unit of strain?
How the water flow is stopped from the valve around the stuffing box?
in third angle projection method the object comes below the_____________and the __________
Which type of pipe joint take branch at 90°?
What is the part marked as ‘x’ in the bearing?
large size thread are cut on a machine called
A screw thread is formed by cutting a __________groove on a cylindrical surface
What is the value of any number raised to the power of 0?
How pipes are classified?
Which bearing carry the load parallel to its bearing axis?
in first angle projection method the object between the _________-and the__________-
in a small size hole the thread is cut by a toll called
the thread cut on a surface of a hole is called ___________--thread
What is the name of bearing?
3 is what percentage of 3000?
Your quiz is running out of time! few seconds are remaining.
