Which chisel used for squaring materials at the corners, joints?
The reciprocal of a proper fraction is
write the shortcut key for 'cut' command
The edge of the drawing board on which t-square is made to slide is called is
uses of the set square ,t-square , scale and protractor are combined in the ___________
Change the verb "took" in the passive voice…
If 295 ÷ 14.5 = 20.34 , then 29.5 ÷ 1.45 = ?
LCM of two number is 24, HCF of two number is 4. If one number is 8 find another?
What is the name of the vice?
Add description here!
Candela is the unit of which of the following?
to draw or measure angles __________is used
What is the name of sign?
measurements from the scale to the drawing are transferred with the aid of a
The singular form of lenses is_____
What is the name of chisel?
for drawing of small instruments , watches etc __________-scale is always is always used
The shape of an ice-cream cone is a combination of:
the size of the letter is described by the
What is the colour code for plastic waste bin?
Which file is used to make the job close to the finishing size?
Which fire extinguisher is used for flammable and running liquid fire?
What are the three factors causes fire?
Surface area of cube of edge ‘a’ is:
What is the name of hammer?
Commas, full stops, question marks – are examples of ------------.
Name the part of a hammer marked as x.
Name the part of file marked as x .
Add description here!
What is the material to manufacture bench vice?
Radius of a cylinder is 7cm. Height is 10 cm find the total area ?
Name the part marked as x of the file.
The silent letter in the word 'answer'
Workplace etiquette means to……
What does the symbol denotes?
________are used to drawing curve which cannot be drawn by a compass
In a right angle triangle Hypotenuse is 5 cm, Height is 3cm find base ?
Which marking media is poisonous?
Always -------------- your mobile phone --------------- silent mode.
the two parts of the t-square are _____and __________
How much less is 10.78 than 30.64 ?
to remove unnecessay lines __________is used
Which marking media provide clear lines on machine finished surfaces?
Name the part marked as x.
What is the use of a try square?
Which caliper is used to mark the centre of round bar?
Which one is an input device ?
